Project 3 - Cut-out Alternation
A pool cover needed a small cut out added... |
 |
 |
1. Area for cut-out identified.
|
2. Cut-out location measured and marked. Tools and materials assembled: Clockwise from bottom right: 1.0" webbing, 2.0" webbing, seam ripper, scalpel, grease pencil, 18" rule, thread nippers, double sided tape, scissors.
|
 |
 |
| 3. Cut lines on top side marked in with white grease pencil. |
4. Cut and fold lines on top side marked in with white grease pencil.
|
 |
 |
5. Webbing unstitched and cut. Raw edges folded and turned under. Viewed from top side of cover.
|
6. Cut and fold lines on top side marked in with white grease pencil. |
 |
 |
7. Webbing unstitched and cut. |
8. Raw edge folded and turned under to bottom side of cover.
|
 |
 |
9. Raw edges cut, taped, folded and turned to the bottom side of cover. |
10. Bottom side reinforcement taped to cover.
|
|
 |
11. Completed cut-out.
|
12. Close up of completed cut-out. |
< Back to repair project photo index |
|
LOOP-LOC Covers are COMPLETELY made in the U.S.A 
Site
design by Tall
Trees Design | Click here to send comments
on the site.
